Complete clean and service and polishing of chamber, feed ramp, and trigger parts.
Basic package plus carry trigger job, tune slide stop, and sights replaced with AmeriGlo Cap Sights or Ameriglo Traditional three dot night sights.
On the customer's supplied Glock we will go through it and conduct a match grade trigger job where the weight is reduced as well as the over travel. A Stainless Steel guide rod with tuned recoil spring is installed along with a grip plug, Vickers Mag Release, Slide Stop, and magazine floor plates. The barrel is upgraded and AmeriGlo night sights installed. A Full Stippling package is completed.
On a customer supplied Glock, we replace the stock magazine release and slide stop with Glock OEM extended mag release and slide stop. The barrel is upgraded and a set of 10-8 Fiber Optic sights are installed. A competition trigger job is completed with an approximate 3-3.5# trigger pull with the over travel reduced. This package is IDPA SSP division compliant.
Basic trigger reduction to approximately 4#. Parts included.
This trigger job takes your trigger down to approximately 3-3.5# with a significant reduction in over travel.
Complete stipple wrap of the hand surfaces.
Stipple of front and back straps of the receiver. This leaves the side panels free of aggressive texture when carrying under garments and against the skin.
These prices are only approximate base prices and are subject to change without notice. Prices to not include applicable sales taxes.